Operation instructions for SWITCH bluetooth controller

1. Setting of controller

* to connect Bluetooth controller, the Controller Connection (Bluetooth) option of the console is On, or turn off Flight Mode;

* on the main page, select controllers-> Change Grip/Order and leave the console in the search bluetooth device state. (this operation is not required for callback)

* note: if the console has difficulty matching Controllers, it may be that the console is connected to too many bluetooth devices and needs to manually remove the System setting-> Controllers and sensor-> DisConnect Controllers.

2. controller matching console

* when the controller is turned off, hold down the small button next to TYPE USB for 3 seconds to enter the code matching state. The 4 leds are in the state of fast flowing water light, and the channel indicator light corresponding to the successful connection is always on. No synchronization within 1 minute will automatically sleep

* if the bluetooth connection is successful, the corresponding channel indicates that the LED is always on (Switch console assignment)

3. Connect the controller back to the console

* when the controller is turned off, press any key to wake up the controller. When the controller is awakened, it will automatically connect to the console with which it is paired, and sleep automatically if the connection fails in 6 seconds.

* after the controller is connected successfully, the controller will not operate and will enter the sleep state according to the sleep setting of the console system. The console screen will close and the controller will automatically sleep

4. Low voltage alarm

* if the lithium battery voltage is lower than 3.55v ± 0.1v, the current channel light flash indicates the voltage is low;

* if the lithium battery voltage is lower than 3.45v ± 0.1v, it will sleep automatically;

5. controller test

* System setting-> Controllers and Sensors->Test Input Devices

*3D test: System setting-> Controllers and Sensors->Calibrate Control Sticks

6. RESET test

* press the small button next to TYPE USB to close the controller;

7. Use distance

Barrier-free operation about 8-10 m.

Product size: 15.5x15x6.5cm

Product weight: 320g

Packing list:

Controller x1, charging cable x1, instruction x1